How to Incubate Chicken Eggs: Temperature, Humidity and 21 Days
By Peter Chan
Researched with AI help and checked against the sources listed below.
To incubate chicken eggs, keep a forced-air incubator at about 99.5–100°F, hold humidity around 55–60% for the first 18 days, and turn the eggs at least 4–6 times a day. On day 18, stop turning, raise the humidity to about 65–70%, keep the lid closed, and expect chicks around day 21.
The details matter, because extension services agree that most poor hatches come from temperature or humidity that is a little wrong for a long time. Below you will find the settings side by side from three university extension services, a day-by-day plan, and a troubleshooting table for the most common hatch problems.
Quick answer
- Incubation time: 21 days for chicken eggs.
- Temperature: about 99.5–100°F in a forced-air (fan) incubator; still-air incubators are run warmer, measured at the top of the eggs.
- Humidity: about 55–60% on days 1–18, then 65–70% for the hatch.
- Turning: at least 4–6 times a day until day 18, then stop.
- Hatch time: keep the incubator closed and the vents open until the hatch is finished.
Before you start: choosing and storing hatching eggs
A good hatch starts before the eggs go in the incubator. You need fertile eggs, which means the hens must live with a rooster (our guide Do You Need a Rooster for Eggs? explains why supermarket-style eggs from a hen-only flock will not hatch).
Mississippi State University Extension recommends collecting hatching eggs soon after they are laid and storing them at 50–65°F, with about 70% relative humidity. The eggs should not warm above 65°F unless you are about to incubate them. Turning or repositioning stored eggs once a day helps stop the yolk from sticking to the shell.
Fresher is better. Mississippi State advises storing most eggs for no longer than one week and gives about three weeks as the maximum for chicken eggs. Illinois Extension gives similar advice: try to set eggs before they are ten days old, and it notes that by three weeks fertility drops to zero.
Do not wash hatching eggs. Mississippi State explains that washing helps bacteria move through the shell pores and removes the egg's natural defences. Clean nest boxes and frequent collection are the better way to get clean eggs. If you must use dirty eggs, the same source suggests incubating them in a separate incubator, because a contaminated egg can burst and spread bacteria to the clean eggs and chicks.
No incubator? If one of your hens goes broody, she can do the job for you; see our guide to hatching eggs under a broody hen.
Forced-air or still-air incubator?
A forced-air incubator has a fan that moves warm air around, so the temperature is fairly even everywhere inside. A still-air incubator has no fan. Warm air rises and forms layers, so the top of the box is warmer than the bottom. That is why the recommended temperature for a still-air model is higher, and why where you place the thermometer matters so much.
Even with a digital display, Illinois Extension advises checking your thermometer, because an error of a single degree over 21 days can seriously affect the embryos.
Incubator settings: what three extension services say
The numbers below come straight from each source. They are close, but not identical, so it helps to see them side by side. If your incubator comes with a manual, follow its settings too, since models differ.
| Setting | Mississippi State Extension | N.C. Cooperative Extension (4-H project) | Illinois Extension |
|---|---|---|---|
| Temperature, forced-air | 100°F; total variation no more than 1 degree | 99.5°F; 99–101°F is all right | Not given |
| Temperature, still-air | 102°F, measured at the top of the eggs | Not given | As near 100.5°F as possible, about ¼ inch below the top of an egg lying on its side |
| Humidity, days 1–18 | 58–60% (about 84–86°F wet-bulb) | 55–60% | Water pan covering at least half the floor area |
| Humidity at hatch | 65% or more | 65–70% (days 18–21) | Raise it for the last 3 days (extra pan or wet sponge) |
| Turning | At least 4–6 times a day; stop after day 18 | Automatic turner used in the project | Do not turn in the last 3 days |
| Ventilation | Open vents gradually; almost fully open late in the hatch | Not given | Keep closed at hatch but never sealed tight |
What they agree on: steady heat matters more than the exact figure, high temperature is especially harmful, humidity goes up for the last three days, and turning stops when the embryos move into hatching position. Where they differ: the exact target temperature (99.5°F or 100°F for forced-air; 100.5°F or 102°F for still-air) and the humidity range by a few percent. A sensible approach is to pick one source, follow it consistently, and check your thermometer.
Day-by-day plan for the 21 days
Day 0: set up and test
Many keepers run the incubator empty for a day or so first, to make sure the temperature and humidity stay steady. Illinois Extension suggests checking the incubator thermometer against a clinical (oral) or laboratory thermometer: hold both bulbs together under lukewarm tap water and compare the readings, then allow for any difference.
Place the thermometer at the level where the embryo develops, near the top of the egg, without touching the eggs or the incubator walls. Mississippi State notes that a thermometer touching an egg gives a wrong reading.
Days 1–18: steady heat, steady humidity, regular turning
Set the eggs with the large end up, or lying on their side with the large end slightly raised. Mississippi State is clear: never set eggs with the small end up. This helps the chick end up in the right position to hatch.
If you turn by hand, mark one side of each egg with an "X" and the other with an "O" in pencil, so you can see at a glance that every egg was turned. Wash your hands first, since oily or dusty hands can lower hatchability, and be extra gentle in the first week, when the blood vessels inside the egg are delicate and can break if the egg is jarred.
Keep the water pan topped up. In a still-air incubator, both Mississippi State and Illinois say the water surface should cover about half the floor area or more, because humidity in these models usually runs low rather than high.
Many keepers candle the eggs during this stage to remove clear (infertile) eggs and ones that have stopped developing. Our step-by-step guide How to Candle Chicken Eggs: What You See Day by Day shows what to look for.
Day 18: "lockdown"
Backyard keepers often call the last three days "lockdown". Stop turning (switch off or remove the automatic turner), raise the humidity, and from now on keep the lid closed. Mississippi State says the embryos are moving into hatching position and need no turning, and that the vents should be opened more as the hatch gets closer.
Illinois Extension recommends putting a cloth on the wire floor of the incubator. It protects the chick's navel and makes cleaning easier.
Days 19–21: the hatch
The first sign is a small crack or hole in the shell, called pipping. Then the chick slowly works its way around the shell and pushes out. Resist the urge to open the incubator to look closer or to help. Mississippi State warns that when the lid is opened during the hatch, humidity can drop within one or two minutes, and the membranes around a pipped chick can dry and stick to it.
Illinois Extension advises letting newly hatched chicks dry in the incubator until they are fluffy, and then moving them to a brooder. If you are hatching in the cold months, our guide Raising Baby Chicks in Winter covers brooder heat and safety.
Common hatch problems and likely causes
This table brings together the explanations given by Mississippi State and Illinois Extension. It is a guide to the most likely cause, not a diagnosis.
| What you see | Likely cause | What to change next time |
|---|---|---|
| Chicks hatch early (before day 21) | Incubator running warm, or humidity too low | Check the thermometer; add water surface |
| Chicks hatch late | Incubator running cool, or humidity too high | Check the thermometer and its position |
| Chick pipped but died in the shell; dried coating around beak and nostrils | Humidity too high during the whole incubation, so the egg did not lose enough water | Keep humidity in range on days 1–18 |
| Chick pipped but stuck; membranes look dry and shrunken | Humidity too low at hatch, often from opening the lid | Raise humidity at day 18 and keep the lid closed |
| Many fully formed chicks die at hatch | Poor ventilation, often from closing vents to raise humidity | Never close vents at hatch; raise humidity with water instead |
| Few eggs develop at all | Old eggs, poor storage, or eggs not fertile | Set eggs within about a week; store at 50–65°F |
Why humidity matters so much
An egg slowly loses water through its shell during incubation. Mississippi State gives about 12% of the egg's weight as the desired loss. Too much humidity for the whole 21 days means too little water is lost, and the chick can drown in the shell. Too little humidity at the end dries the membranes so the chick cannot turn. That is why the humidity plan has two stages.
Why you should never close the vents at hatch
It is tempting to close the air holes to push humidity up on day 18. Mississippi State explains why this is a mistake: a chick's need for oxygen is greatest on the last day, when it starts breathing with its lungs. Closing the vents can suffocate chicks that were healthy enough to pip. Raise humidity by adding water surface, such as an extra pan or a wet sponge, and if you change the vents at all, open them more.
Chicks that hatch with legs sliding out sideways may have splay leg, which Virginia Tech Extension links partly to incubation conditions. Our guide to splay leg in chicks explains what to do.
Quick checklist before you set the eggs
- Fertile eggs, unwashed, collected soon after laying, ideally less than a week old.
- Incubator run for at least a day with steady temperature and humidity.
- Incubator thermometer checked against a clinical thermometer.
- Thermometer placed at the height of the top of the eggs, not touching anything.
- Eggs set large end up (or on their side), never small end up.
- Turning plan (automatic turner, or X/O marks and a schedule).
- Calendar marked: day 18 lockdown, day 21 expected hatch.
- A warm, ready brooder for the chicks after they dry.
After the hatch, check every chick for droppings stuck over the vent. Our guide Pasty butt in chicks explains the causes and how to prevent it.
FAQ
How long does it take chicken eggs to hatch?
About 21 days. Mississippi State's incubation chart lists 21 days for chickens, with turning stopped after day 18. A warm incubator tends to bring the hatch earlier and a cool one makes it later.
Can I hatch eggs from the supermarket?
Only fertile eggs can hatch, and that needs a rooster living with the hens. Eggs that have been washed or stored for weeks are also poor choices, based on the storage advice above.
Have you tried hatching eggs in an incubator? What surprised you most? Tell us in the comments.
Like this guide? Follow CluckSmart on Pinterest for more simple, sourced chicken care guides and checklists.
Sources / Further reading
- Mississippi State University Extension – Important incubation factors (also its pages on hatching egg storage and washing hatching eggs)
- Mississippi State University Extension – Pipped eggs that do not hatch
- Illinois Extension – Reasons for Poor Hatches
- N.C. Cooperative Extension, Haywood County – Setting Up an Incubator
CluckSmart is an educational resource, not veterinary advice. If a bird is ill or injured, contact a licensed vet.

Comments
Post a Comment